SUMMARY: This section provides a list of items that are required to be checked during the final assembly and after installation of the bike, to ensure that they have been put together correctly, working correctly, installed correctly, every time, for every Customer. Note: This checklist must be used during the build and during the installation of bike. Note: Failure to assemble or install the bikes correctly, could result in installer having to go back out and fix bikes at no cost to Stages Indoor Cycling, or back billing the installer for work that may need to be performed, as a result of the improper assembly or installation of bikes.

 

DETAILS:

 

PRE/POST INSTALLATION CHECKLIST

Check forward/aft slides on seats and handlebars


Silicone


Set to 0 (and tightened)

Check up/down slides on seat and handlebars


Silicone


Handlebars all set to same height (and locked into place)(if more than 1 Les Mills bike in facility)


Seats all set to the same height (and locked into place)(if more than 1 Les Mills bike in facility)

Check and adjust the tension on the Pop-pin


Handlebars


Seats

Check bike leveling


Adjust stabilizer to floor (adjust all the way up first into stabilizer, then to floor)


Tighten nut against stabilizers after leveled

Check tablet and bracket


Ensure tight on handle bar stem


Ensure set to the back of handlebar stem

Check tightness of all


Tablet/tablet base


Stabilizers


Power Meter


Pedals


Seats (level and in-line with handlebars)

Update Stages Power Meter 


Check for firmware update via the StagesPower App

Complete Virtual Bike tablet set up


Les Mills Virtual Bike – follow procedure that begins on page 14 of the Les Mills Virtual Bike SOP


Stages Solo Bike – follow procedure that begins on page 16 of the Stages Solo Bike SOP

Ride and function check the bike


Listen for rubbing noises (metal to metal, plastic, etc.)


Listen and feel for vibrations


Test resistance knob and SprintShift lever


Tablet is displaying watts and rpms (if all functioning, perform zero reset) Via the StagesPower app


Perform adjustments as necessary


Remove any extra packaging material

Ensure bikes is positioned in customers requested location(s) (post install only)

Clean bikes

 

Next Step:

Please have the customer sign below acknowledging satisfactory completion of virtual bike installation and return this form to [email protected].



Customer:                                                                                                                                     Date:                     


Install Agent:                                                                                                                                Date: