For full details or additional help, please see pages 21-23 in the Stages Indoor Cycling SIC1 Console User Guide


Note: Pairing the power meter only needs to be performed on a new console upon installation. Once paired, the console will remain attached to that specific power meter.


Guide to console buttons:



To exit the SETTINGS mode, press the AVG/END button



Pairing Steps


1. Activate the console by pressing any button.


2. Press and hold the BACKLIGHT and AVG/END buttons for 5 seconds to enter the SETTINGS menu


3. Use the AVG/END button to advance the settings menu and hit STAGE to enter PAIRING


4. Select PWR METER with the STAGE button, then select ENTER ANT. Locate the ANT+ ID on the sticker attached to the left crank arm.


Locating the ANT+ ID: The 4-5 digit ID number appears in several stickers applied to the crank arm.


5. Enter the ANT+ ID from the crank sticker in using the following keys:

Use the BACKLIGHT button to advance the digit. The number will increase from 0-9 and return to 0.


Use the AVG/END button to move to the next digit. The highlight will move from left to right and return to the first digit.


6. Once the ANT+ ID displayed matches the power meter, press the STAGE button to begin pairing

Spin the power meter on the bike. This will wake the power meter and allow the console to link to it.


7. Complete the pairing process

If the pairing process is successful, the word PAIRED will appear in the message banner. 


8. When ZERO RESET is displayed on the screen, press the STAGE button to begin the zero reset process

Place the crank arm in the 6 o'clock position with NO weight on the pedal to successfully zero reset. This process will take several seconds, but the console will display SUCCESS once it is completed. If FAILED appears, please attempt the zero reset again after ensuring the crank is in the proper position.



Troubleshooting


What to do if the pairing has failed?

1. Check that the crank has new batteries installed,
2. Make sure the crank has been rotated,
3. Hold the console close to the power crank in order to avoid interruptions from other ANT+ devices in the area


What if you do not know the ANT+ ID?

Enter all zeros in for the ANT+ ID and the console will search for the power meter.